I used Auber SYL-1512A PIDs for the mash temperature displays.  These are not used in Kal’s original design.  The following is how I set them up.

Enter system configuration menu
1. push set
2. enter 0089
3. push set
In the system configuration menu change the follow entries
1. intY to PT100 (for probe type)
2. outY to 0 (output set to alarm only)
3. PSb to correct your temperature probe reading if necessary
Exit the system configuration menu

Optional – I have not set this filter value but I may if the temperature display is jumpy.

Enter tuning/performance menu
1. push set
2. enter 0036
3. push set
In the tuning/performance menu change the follow entries
1. filt to 1 (for weak filtering, default is 0 for no filtering)
Exit the tuning/performance menu